Paul Tradelius

Thunder Tiger RL-53H Ringed Redline Engine

Jun 14, 2011 No Comments

The Thunder Tiger RL-53H Ringed Redline Series Two-Stroke Helicopter Engine (Tower Hobbies stock number L5AHTG02) features CNC construction with a low profile cylinder head which is anodized a bright red. The two-needle carburetor uses a push/pull throttle lever and a heat insulator between the carb and the engine case for consistent performance under demanding flight [...]

Read more

G-Force Spindle Tool

Jun 13, 2011 No Comments

It’s not very often that I need to disassemble the spindle in the main rotor head, but when I do it’s always a chore to get out the second retaining bolt. But now, using the G-Force 4-in-1 Spindle Tool (part # GFA7077) the job is a snap. Just clamp the tool on the spindle and [...]

Read more

Flybarless Fury Continued

May 31, 2011 No Comments

The original receiver, battery pack and gyro have been removed. The CGY750 flybarless gyro is mounted to the right side of the frame with double stick tape. In a similar manner the new  Futaba receiver is mounted to the left side of the frame with double stick tape, and the new 3200 mah LiFe Source [...]

Read more

Flybarless Fury Conversion

May 28, 2011 No Comments

I have had this Miniature Aircraft Fury for more years than I care to remember, and it has always been a great flying helicopter, so I thought it would be a great candidate to convert to flybarless operation. The stock head, wash out unit and swashplate were removed and replaced with the RJX Flybarless Head [...]

Read more

Red Black RC Swashplate from HeliFlightCenter

May 21, 2011 No Comments

For all the years I’ve been flying helicopters (which is longer than I care to admit) all swashplates have had the same basic design. They all use a center ball which rotates in all directions. Although this has always worked well some slop could develop over time with a lot of use.  Some companies such [...]

Read more

Pantera P6 Build Cont.

May 15, 2011 No Comments

The build on the P6 starts as I wait for the servos and engine. This is a pic of the basic rotor head and swashplate, which come fully assembled. There are so many factory assembled parts that I would almost consider this to be an ARF vs.  a kit.  Note the one-piece flybar cage. The [...]

Read more

Heli Engine Bearings

May 12, 2011 2 Comments

I received the following question from Tony about his engine bearings. I have a question on bearings rusting in helicopters. Specifically, my heli engine bearings never seem to give me any problems. My airplane engines, stored in the same environment and using the same 20/20 heli fuel seem to all corrode and rust up within [...]

Read more

Mavrikk Glow Plug Wrench

May 09, 2011 1 Comment

Glow plug wrenches have been around longer than I have, and they all do a great job. However, when installing a glow plug deep inside a helicopter my technique is to push the stem of the glow plug onto a small piece of fuel tubing.  I use this to feed the glow plug to the [...]

Read more
Copyright © Air Age Media. All rights reserved.
click me