Exclusive! Hangar 9′s Giant Corsair Part 2

Exclusive! Hangar 9′s Giant Corsair Part 2

[For the first part of this build, click here)

 

Sept. 12

The Corsair build continues on, here are some construction pictures from yesterday’s work

Hangar 9′s Giant Corsair

I installed my tank and my throttle servo, now all that remains is to button up the front and install the cowling.

Hangar 9′s Giant Corsair

The Cowl only required one cut a hole for the exhaust. The Evolution 77cc radial engine is a perfect fit and looks way better than the dummy engine. But those looks do come at a price :-). I can’t wait to fire up this engine.

Hangar 9′s Giant Corsair

Today’s project is to install the scale cockpit in the corsair. All of the parts are included in the kit. Along with two canopies, a two piece one that can open and a single piece canopy that is closed.

Hangar 9′s Giant Corsair

This is the empty cockpit that will soon have all that stuff inside.

**********************************************************************

Sept. 13

some more images

Hangar 9′s Giant Corsair

Here is my finished cockpit with my WWII pilot. If one was inclined they could really detail this thing out, which I will do at a future time. One of the reasons I went with a sliding canopy.

Hangar 9′s Giant Corsair

Attaching the front part of the sliding canopy. Not only does the rear part of the canopy move but it can also come off for any future work I may do inside the cockpit.

Hangar 9′s Giant Corsair

Now it is onto installing the bomb drops. There is a full proof way of laying out the pylon attachment holes outlined in the manual.

 

 

Updated: July 27, 2015 — 12:31 PM

7 Comments

  1. Is that the end of the reveiw? Finished photos, flight reveiw?

    1. The full review is in the January issue of Model Airplane News! 🙂

  2. What battery did you use for the Robart electric retracts? Did you use a sequencer for the gear doors?

    1. For now I am using the flight batteries (they are rather large) but I will be adding a separate one for the gears soon. The DX18QQ has a sequencing program that I will use for the gear doors when I install them.

  3. John, How did you hook up the fuel tank and the fuel lines so they are not being pinched. Also were did you install the fuel filler line?? I am using the Evolution 77 CC Radial as well
    Thanks for help. Can you please email me @ pjrusso19@yahoo.com

    1. Hi Perry,
      I installed the tank as per the instructions and I don’t remember any of the fuel lines being pinched. I also like to use some of silicon sealer around the opening where the fuel lines exit to seal that up and prevent any fuel from seeping into the tank compartment. I did use that filter at first but switched to a higher grade one after a little while.

Comments are closed.

Air Age Media ©
WordPress Lightbox