The HobbyKing Aether is back and better than ever!
The fuselage is now fully fabricated from epoxy and where possible carbon fiber has been used for some parts providing exceptional strength without a weight penalty. The fiberglass firewall now comes pre-drilled ready to accept a motor of your choosing.
The large size and low cost make this a perfect entry level ALES model.
The Aether arrives as an almost ready to fly model, allowing you to customize it how you choose. Though it is a large model it disassembles easily. The wing breaks down into 4 pieces with a rugged carbon tube joiner for the center two wing panels and the tail assembly bolts to the fuselage and that means it will fit it all but the smallest of vehicles.
The large volume pod gives plenty of space for your battery and other equipment with access through the large carbon fiber canopy hatch being a breeze. The large wing, along with a generous amount of wing dihedral makes the Aether 3700 ultra stable. so its relaxing to fly and with large flaps to slow the model down, landings are feather light.
If you have never flown a large model, the Ather is confidence inspiring, a great way to enter large model flying. All up the Aether is a stunning piece of kit and we’re sure you’ll love flying it.
- Almost Ready to Fly – Complete final assembly, install electronics, and fly!
- Built up balsa wing and tail surfaces covered light weight iron on film
- Sheeted D-tube leading edge
- Fiberglass fuselage pod, with woven carbon fiber boom.
- 4 piece wing for easy transport
- Affordable entry level ALES model
- Bolt on tail surfaces
- Complete hardware pack
- Airfoil AG24
Flying Weight: 2300g w/o battery
5 Channel Transmitter and Receiver
4~5S 14.8~18.5V 3300~5000mAh Lipoly Battery
60~80A Brushless ESC
6 x 22g Servos
35 size Brushless motor
50mm Spinner and Folding Prop
#9110000035-0 – $335.40