Workshop Tips — Working with Laminated Parts

Workshop Tips — Working with Laminated Parts

So, last night I finished the center cutout bow for the Camel’s top wing. In all, it took about 48 hours for the laminated balsa strips to fully dry and lock into a ridged lamination. Here’s how I incorporated the new formed part into the Sopwith’s wing structure.

IMG_1331

Last time, we left off with the balsa strips drying while “clamped” to the forming block.

IMG_1336

You don’t try to remove your part from the forming block, rather you remove the block which easily lifts out of position once you pry up the two nails holding it in position.

IMG_1338

Here’s the laminated bow free of the clamping nails. It is quite stiff and holds the exact shape of the forming block.

IMG_1339

Since I used the wing plans to make the forming block, the bow fits perfectly in place without any adjustment or pulling or pushing.

IMG_1340

Before gluing the bow into place, sand the bottom edges smooth with a sanding block or carefully smooth it on a belt sander.

IMG_1341

Make sure to position the bow so there is a little material proud of the bottom surface so it can be sanded to shape flush with the wing later on.

IMG_1342

Trace the outer shape of the bow on the trailing edge sheeting and cut it to fit snuggly against the bow. Glue the bow into place and use a razor saw to rough cut the bow to shape.

IMG_1343

Plane the bow down and shape it so it is almost level and flush with the top of the wing. Draw the plane from the center and work out to the trailing edges.

IMG_1349

When the shape is close, switch to a sanding bar and dress the bow down smooth and flush with the top surface of the wing.

IMG_1345

Here’s the bow sanded smooth and flush with the wing.

IMG_1346

After the bow has been sanded to shape, sand the ends of the bow even with the trailing edge and then round the ends of the bow as shown here. Also note how precise the joint is between the bow and the bottom trailing edge sheeting.

IMG_1347

The top center of the bow should be flush with the balsa filler strip glued to the end of the center ribs.

IMG_1352

There you have it. One perfectly shaped laminated balsa bow to finish out the center cutout above the pilot’s head. This is the only laminated piece in the Sopwith Camel but the same technique can be used to make delicate looking yet very stiff wing tips, and the outlines of tail surfaces.

Give it a try, once you know the technique and details, the rest is easy!

To see how to form the laminated bow, chick the link: https://www.modelairplanenews.com/blog/2014/09/02/workshop-tip-laminating-balsa-parts/

 

 

Updated: July 23, 2015 — 4:33 PM

3 Comments

  1. I made somewhat more permanent laminating “jigs” for my Proctor 1/6 Camel. Stored them with the plans.

  2. Another way of ammonia-soaking balsa is to use a PVC pipe of suitable diameter and length. One end has a cemented-on cap, and, to cut down on evaporation and ammonia odor, I use a tight-fitting, push-on cap on the other end. My 6-inch I.D., 50-inch length Schedule 40 pipe will handle even my widest and longest leading-edge sheeting. For ease of extracting shorter lengths, I drill a small hole in one end of the wood and tie on a length of mono-filament fishing line. Other than topping off, the solution keeps for several projects.

  3. Why the ammonia?. I used nearly the same procedure several years ago building a Lazy Bee, I believe used only hot water to soften the balsa. But, then that’s been a while ago..

Comments are closed.

Air Age Media ©
WordPress Lightbox