ElectriFly, SU-31 3D E, electric rc, rc model, model aircraft |
ElectriFly SU-31 3D E-Performance Series.
FEATURES:
Construction: Balsa and ply with prehinged ailerons and rudder andairfoiled control surfaces, motor box preinstalled with blind nutsproviding perfect spacing for spinner backplate-no need for measuring, cowl ring also preinstalled Wings: Two piece with carbon fiber wing joiner, secures to fuselage with wing hooks and rubber bands inside fuselage Motor Mount: Built-up plywood Covering: Top Flite MonoKote Aileron Control: Dual servo Cowl: Prepainted fiberglass, attaches with rare earth magnets Canopy: Clear, single Wheel Pants: Prepainted ABS Landing Gear: Prepainted aluminum 0.079″ (2mm) thick Wheels: Two foam 1.75″ (44mm) diameter Spinner: White plastic, 1.75″ (44mm) diameter Hardware: Full set included Building Time: Approximately 4-6 hours
INCLUDES:
ElectriFly ARF SU-31 3D Aerobatic Airplane with fiberglass cowl,
ABS wheel pants, landing gear, wheels, hardware, photo-illustrated
instruction manual and two decal sheets
REQUIRES:
- Radio: 4 channel computer radio recommended
- Servos: 4-micro
- Dual Servo Extension: For aileron servos
- 6″ (150mm) Slim Extension Wire: Two
- 12″ (305mm) Servo Extension: Two
- Motor: Rimfire 35-30-1250 outrunner
- 35A ESC for Brushless Motors
- Battery: LiPo 1250 – 1500mAh 11.1V
- Cell Balancer: For LiPo battery,
- Battery Charger: LiPo compatible
- Propeller: 10x7E
SPECS:
Wingspan: 41″ (1040mm)
Wing Area: 343 sq in (22.1 sq dm)
Weight: 27.5 – 31 oz (780 – 880g)
Airfoil: Fully symmetrical, mid wing placement
Wing Loading: 11.5 – 13 oz/sq ft (35 – 40 g/sq dm)
Length: 38″ (965mm)
Center of Gravity: 2-5/8″
Control Throws- Low Rate High Rate 3D
Elevator: 3/8″ (9.5mm) 7° 1/2″ (12.7mm) 10° 2-1/4″ (57mm) 48°
Rudder: 1-1/4″ (32mm) 16° 2″ (51mm) 26° 3-1/4″ (83mm) 45°
Ailerons: 1/2″ (12.7mm) 11° 3/4″ (19.1mm) 14° 1-5/8″ (41mm) 32°